Tc-electronic M350 Instrukcja Użytkownika Pobierz pdf (Strona 6)

QUICK START – IF YOU JUST CAN’T WAIT

If you just can’t wait to hear the great

effects waiting for you in your new M350

Dual Effects processor, follow the few steps

in this quick setup guide:

• Unpack the M350 and check for possible

damages that could have been caused by

transport.

• Read the safety instructions.

• Take a few minutes to register online via:

www.tcelectronic.com or send in the

registration card. Customers registered

online will be notified directly via E-Mail

about new tips & tricks and manual updates.

Consider the M350 as two effects processors in

one box. We call these two processors

“engines”. The Delay/Effects engine creates

one of the following effects: Delay, Chorus,

Flanger, Phaser, Tremolo, De-Ess or

Compression. The Reverb engine creates

Reverb.

These two Engines can be used separately or in

conjunction.

Connections & Routing:

The M350 has two routing options that require

two different ways of connecting.

The Routing mode is set on the M350 rear

panel and should correspond to your current

setup.

Serial Routing (switch in OUT

position)

– utilizing both effect Engines in serial.

Dual Input mode (switch in IN

position)

– ideal if you need to send signals from two

different aux sends on your mixer and return on

a stereo aux or two other channels.

For detailed explanations on Routings and

connections please read page 23.

• When all audio connections are made,

connect power.

• Set the M350 to Preset Off mode using the

PRESET ON/OFF key:

The M350 is in Preset Off mode when the

display reads as illustrated above.

• Set all controls in 12 o’clock position to

hear factory settings.

(For Dual Input mode set MIX to 100%.)

• Select an effect from the Delay/Effects

section.

• Select a reverb type from the Reverb section.

• Start playing music through the M350.

• Adjust input level to a level just below the

point where the two INPUT PPMs turn red.

• Set the desired mix between the dry and wet

signal of the entire M350 using the MIX

control.

• Set the desired balance between the

Delay/Effects engine and the Reverb engine

using the EFFECT BALANCE knob.

• Now tweak the controls for the two sections

until you have the intended effects.

• (When using the Dual Input mode always set

MIX to 100%)

For any questions left unanswered by this

manual feel free to visit our online support

center; TC Support Interactive, which can be

accessed via: www.tcelectronic.com

Latest manual revision can always be

downloaded from www.tcelectronic.com

4

1 2 3 4 5 6 7 8 9 10 11 ... 33 34

Komentarze do niniejszej Instrukcji

Brak uwag